STAINLESS STEEL TANK ALWAYS FILLED 1.000 LITERS FUND INCLINED 5%

3 504,16 €

Add to cart



IVA incluido

DESPID1000

Always full tanks, to avoid air chamber inside, with a flat bottom inclined 5% very suitable for winemaking with skins or skins and storage. Unlike the models with a conical bottom, once the fermentation and deviation have finished, the manhole and the bottom inclined to the door make it easier to remove the skins. They are also equipped with an internal strainer grid for pumping over. Automated self-emptying tanks with propeller and conical bottoms with sash doors (hydraulic or pneumatic) can be manufactured in this line. FINISHES: * stainless steel sheet: interior and exterior matte finish. Body sheet thickness 2mm from 3.000 litres* TIG welds with inert gas, coated, passivated, brushed. DETAIL * Upper part: Tubular profile of peripheral reinforcement by torsion of the same sheet giving the necessary reinforcement. Floating lid in stainless steel with semicircular perimeter of double lip for the perfect coupling of the air chamber. Rope fixing anchors to be able to pull the cover. Double acting safety valve (pressure / depression) in plastic. Support for arm placement with pulleys. Rotating arm with knob and pulleys for the passage of the rope facilitating the lifting of the lid.

* Cylinder: Support for the rope collection winch, facilitating the raising and lowering of the cover. kit always full complete. Complete level with 304l stainless steel gas tap with plastic hose, with calibrated profile of general capacity. Nameplate and identification. Supports stairs from 3,000l. Tap takes samples in stainless steel. Rectangular lower mouth with external opening, complete with gasket, closing flywheel and bolts. Front thermometer holder pod.

* Bottom: Flat bottom inclined 5% with a slope towards the front to facilitate the deviation and removal of the skins. Total drain outlet next to the lower mouth at the bottom of the 304 stainless steel butterfly valve NW 50 male outlet.

Video demo

More details

May contain traces of machining fluid and undesirable odors.
A good cleaning is necessary to avoid migrations.
Smell the inside of the taps.

In the case of oil, the air chambers affect the rubber with its acidity, so it is recommended to carry out regular inspections and have spare chambers.

Optional: adaptation of agitators, inertisation, external cleaning tube with internal shower, thermal jackets, search for clear ... (on request). Material of construction all in stainless steel 304l, possibility of construction in 316l on request.

* Identification and approval: Sanitary registration of industries and food products RSPAC 3905561 / CAT. In accordance with the provisions of article 4, 5th paragraph of D.L. 01/25/92 No. 108 and CEE directive 89/109. Identification plate for manufacturing, cubing and identification.

Wrap-around heat exchange jacket with 1 "gas fitting. Rear thread with plug for PT100 probe. Pumping tube from 3,000l. Inner strainer grid with external outlet for NW 50 male butterfly valve to facilitate pumping and retaining the skins.

  Tapered feet with nut and adjustable bolts for perfect alignment (+ / - 60mm). With stainless steel floor support plates diameter 140mm.

Capacity Diameter Approximate Total Height Approximate. Thickness plates Nº Legs Height Shirt
 1000 ltrs 940 mm 2500 mm 2 mm 3 500 mm
1500 ltrs 1155 mm 2500 mm 2 mm 3 500 mm
2000 ltrs 1275 mm 2500 mm 2 mm 3 500 mm
2500 ltrs 1325 mm 2900 mm 2 mm 3 500 mm
3000 ltrs 1405 mm 2900 mm 2 mm 4 750 mm
5000 ltrs 1845 mm 2900 mm 2 mm 4 750 mm